Did you know that “INSANITY” is defined by doing the same thing over and over again and expecting different results? 

  Replace drywall, install new cabinets, moldings, flooring, furniture…wait for it….BOOM!  the next storm surge (not hurricane) your home is damaged again. Be angry at those property owners who drove past your home and created a wave that gets your house wet. How dare they leave the house they own to get away or go the house they own to check damage. You have every right to be upset, you just replaced all of the damage created from the last flood and now your home is damaged again. 

If your house flooded from a storm surge and you only replaced everything, you could be INSANE. You need different solutions to stop future water damage.

• Where was water infiltration entry?

• How high was the surge and water level outside and flood water inside?

• What height (off the floor) are the entrance doors to the house?

  Take this information and create a plan.

  Most likely the height of the water level caused the damage. Raise all of your door entrances up as high as possible. Replace the space above your doors to installing that space below your doors. Add a landing outside to enter, and one inside if needed. Waterproof the lower elevation of your home, the entire perimeter. There are many waterproof membranes that can be applied as paint and will stop any water from entering. Besides being easy to apply, you can also paint over so it is not visible. Build the grade around your house up, add planting beds to buffer water and make sure you waterproof continuously behind and higher than the beds prior to creating the beds. Your garage, raise everything off the floor, be sure to waterproof the all of the walls 24″ up and to the concrete slab. Remove HVAC units, water heaters anything in the way and replace after applications are applied generously. Cover the entire concrete slab, be sure to raise the entrance door from the house to the garage to the max and add landing as needed.  

  Raise your exterior doors to create a buffer below. This work may be involved but if you do it once correctly you won’t have to do it again unless something huge came through. If your home has 8ft ceilings and you door sits on the floor of your home, you have these options:

• Option 1 remove the lintel and replace with a laminated wood beam that is short in height and fat. Use the difference in height to raise the door with cement infill and waterproofing. A typical door is supporting 1 or 2 trusses so a 4″-5″ tall laminate beam is suffice. 

• Option 2 remove the lintel and open the ceiling up inside, install a flush header above the block walls and joist hanger the trusses into the beam for support. put your door to the ceiling line and add the space below with cement and waterproof to bottom of footing. 

• Option 3 open the ceiling, remove 2-4 trusses entirely, create a reverse gable roof and infill with framing. Raise your door 2ft and create an entrance outside and inside. Be certain to waterproof your exter to the bottom of your footing or at the least to the top of your footing well below your concrete floor elevation. 

What is the cost? What is the amount of work involved? Slightly more than the work to replace what is damaged. So if you do this work while you are repairing your home the cost is nominal and you would not feel it. You would stop the stress worrying about flooding again, you would also increase your homes value. When you have a claim on your home it is noted and recorded. Your premiums and future owners premiums will be higher and it will be an issue later. 

Recap, doing the same thing and expecting different results is Insane. 

Give us a call we provide free estimates and we can help you. 561-597-0021